With the new Star Wars film, The Force Awakens, being released I decided to get into things with a quick and easy build. This was a bit of an impulse buy, I was in my local hobby store when the first batch had just arrived and the owner let me have one before they were even out of the shelves.
I've had fairly strong opinions on Revell and their Star Wars range but I was more than prepared to give them a fair chance here. I really wanted this kit to be a good one.
So to the kit, I was a bit hasty in getting started so I actually forgot to photograph the sprues so I'll direct you to Britmodeller's in-box review. The parts count is small, 22 in all but they do look reasonably detailed.
The wings, (for want of a better word), are both single pieces which was noticeable when compared to other kits in which the solar collector arrays are a single piece with a separate frame that attaches to them. I can see why because it's simpler for the novice builder, but if you want to airbrush them it'll involve a lot of masking as you spray the dark panels and then the grey coloured frames.
Up until now I've been avoiding the elephant in the room. That scale! 1:110. Just ignore this, especially if you wish to combine this with models from other ranges. This kit is actually bigger than the FineMolds kit and the Bandai kit both of which are 1:72 scale (and both of which scale up the same next to each other).
Now I appreciate that we're talking about the scale of fantasy vehicles and so with that in mind I measured up the pilots in all 3 kits. FineMolds and Bandai both were 1:72 scale, this kit was nearer to 1:50 scale. So why put a scale on it the first place? This seems very misleading if you're a modeller as really this is a toy kit. Looking a bit further at the history of this kit it then became apparent that this is actually Revell's 2012 Easykit Pocket TIE fighter, re-boxed and with the parts unpainted. Suddenly this looks like a rather lazy re-release just in time for the new film.
So how did it build? It goes together fairly well, in fact it's almost a push fit kit. The cockpit has a large hatch to the top which is meant to open to allow you to see inside (and see the oversized pilot). Again this seemed to emphasise the toy like nature of the kit.
Unfortunately this where my pride takes a bit of a knock. Due to the tight fit of the parts my dry fitting wasn't a thorough as it should have been and the hinge for the hatch ended up catching on the rear wall of the cockpit preventing the two halves from going together. How embarrassing...
So at that point there was only one place it was going, in the bin. I can't say I'm that bothered as I've already built the FineMolds kit and, despite the restrictions, I have one from Bandai to be getting on with.
I have to say when I saw all these kits in the store I though about getting a few other Star Wars models to quickly build. But with this experience I've changed my mind. I feel that there are much better options out there from Bandai and now, also, from Dragon who've just announced their new Star Wars range for 2016.
 |
| Dragon - Phase 1 Star Wars Releases |
Overall Build Score: 2 out of 5, The detail is reasonable and a low number of parts makes it ideal for younger modellers. While it is relatively inexpensive it is essentially a repackaged Easykit Pocket TIE fighter from a few years ago without the pre-coloured parts. Combine this with very odd and completely wrong scale(s) make it feel like a somewhat lazy attempt at a cashing in on Star Wars as the new film is released.
No comments:
Post a Comment